Filter
Top Products
9
PROGRAMMING DEVICE MODE CONTROL
3. Align the keys in the cover with the keys in the case
and press the cover back into place. The tab should click
when the cover is locked.
4. Test the remote control by pressing any
mode key (e.g. TV.) If the batteries are inserted
correctly, the LED (red light) will blink once.
NOTE: When batteries need replacement, the mode LED
blinks 5 times with each key press. Replace the batteries
and the unit will be restored to its full functionality,
complete with your favorite settings.
The Teleport™ Remote Control is pre-programmed to
operate an RCA satellite receiver, TV, DVD player, and VCR.
It can also control Z-Wave
®
certified devices, regardless of
manufacturer. To control devices other than the default
brands, perform the following steps; otherwise skip this
section.
NOTES: For control of a Combo device (for example, a
TV/VCR combo), skip this section and perform the
instructions on “Setting Up a Combo Unit” on page 11.
Also, refer to “Device Table” on page 8 to determine which
devices can be programmed onto each device key.
1. Turn on a device and, if applicable, insert video media,
(e.g., cassette or disk.)
NOTE: Please read Steps 2 - 4 completely before
proceeding. Highlight or write down the codes and device
you wish to program before proceeding to Step 3.
2. On the remote control, press a mode key
once (i.e., TV, DVD/VCR, SAT or AMP); it will
blink once. Then press and hold SET UP until
the selected mode key blinks twice.
3. Use the “Manufacturer’s Codes” (starting on page 31)
to locate the type of device and brand name, then enter
the first five-digit code for your device. If performed
correctly, the selected mode key will blink twice.
NOTE: If the selected mode LED emits one long, steady
blink, the operation was not successful; repeat the
sequence.
Continued next page...