Filter
Top Products
If Teleport™ is your primary controller in your Z-Wave
®
network, you can add a secondary remote and transfer
Teleport™’s node and network information to it.
Teleport™ will remain your primary controller and is the
only controller that can add or delete Z-Wave
®
nodes to
your network.
1. Place the two controller’s near each other.
2. Press the HOME mode key on Teleport™.
3. Press and hold SETUP until the HOME red LED blinks
twice.
4. Enter 966 on the numeric keypad. The HOME red LED
blinks twice.
5, Press CH+; the HOME red LED blinks rapdily.
6. Put the target (secondary) controller into receive
mode. Refer to the target controller’s user manual for
specific instructions.
The HOME green LED blinks twice to indicate a
successful operation.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
7. Add nodes, groups, and scenes to the new secondary
remote as needed.
Adding Nodes to ALL CONTROL
1. On Teleport™ press HOME once.
2. Press and release ADD once.
3. Press ALL once. The HOME red LED blinks rapidly.
4. Press the program button on the Z-Wave
®
node.
The HOME green LED will blink twice to indicate the
operation was successful.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Deleting Nodes from ALL CONTROL
1. On Teleport™ press HOME once.
2. Press and release REMOVE once.
3. Press ALL once. The HOME red LED blinks rapidly.
4. Press the program button on the Z-Wave
®
node.
The HOME green LED will blink twice to indicate the
operation was successful.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
TRANSFERRING NODE AND NETWORK
INFORMATION TO A SECONDARY REMOTE
24