Filter
Top Products
22
A Z-Wave
®
SCENE is a one or more Z-Wave
®
nodes that
can be pre-set to turn to a previously specified setting (ON,
OFF, DIM brightness level, etc...). The Teleport™ remote
control allows you to set up a maximum of 20 scenes,
containing up to 64 nodes per scene.
1. On Teleport™ press and release HOME once.
2. Press and release ADD once.
3. Press and release SCENE once.
4. Press and release a scene number for the scene you
wish to add the node to. For scenes 0 - 9 press and
release the number for the scene (e.g. 2 for scene 2,) for
scenes 10 -19, press SETUP then the second digit of the
scene number (e.g. SETUP + 4 = scene 14.) The HOME
red LED blinks rapidly.
5. Press the program button on the node.
6. The HOME green LED blinks twice, then the HOME red
LED blinks rapidly. Adjust the brightness on the Z-Wave
®
node within 30 seconds. To configure the node to turn
on/off to max/min levels, simply press OK without
adjusting brightness.
7. Press OK to save the node in the scene.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Be certain Teleport™ is within 3 ft. of the the node.
Adding a
Z-Wave
®
Node to a SCENE
SETTING UP Z-WAVE
®
SCENES
1. On Teleport™ press HOME once.
2. Press and release REMOVE once.
3. Press and release SCENE once.
4. Press and release a scene number for the scene you
wish to remove the node from. For scenes 0 - 9 press
and release the number for the scene (e.g. 2 for scene 2,)
for scenes 10 -19, press SETUP then the second digit of
the scene number (e.g. SETUP + 4 = scene 14.) The
HOME red LED blinks rapidly.
5. Press the program button on the node.
6. The HOME green LED blinks twice, then the HOME red
LED blinks rapidly.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Removing a Node from a SCENE