Filter
Top Products
27
Z-Wave
®
Network Reset clears all Z-Wave
®
node and
network information from Teleport™.
1. Press the HOME key on Teleport™.
2. Press and hold SETUP until the HOME red LED blinks
twice.
3. Enter 969 on the numeric keypad. The HOME red LED
blinks continuously.
The HOME green LED blinks twice to indicate a successful
operation.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Z-WAVE
®
NETWORK RESET
Network re-discovery is used to make your Z-Wave
®
network more efficient and improve performance if, for
example, a Z-Wave
®
plug-in module was moved across
the room.
NOTE: This operation requires Teleport™ to be the
primary controller.
CAUTION: This operation may take several minutes
depending on the size of your network.
1. On Teleport™, press the HOME key.
2. Press and hold SETUP until the HOME red LED blinks
twice.
3. Enter 961 on the numeric keypad. The HOME red LED
blinks continuously.
The HOME green LED blinks twice to indicate a successful
operation.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Z-WAVE
®
NETWORK RE-DISCOVERY