Filter
Top Products
iPump 6420 User’s Manual
www.wegener.com 800070-01 Rev B Appendix 1, Page 110
Usage:
PORT [number] [datarate] [settings]
number = 1 or 2 for the two RBDS DB9 connectors
datarate = 1200, 2400, 9600
settings = (7|8)(N|E|O|M|S)(0|1|2)
Command - PROFILE report: Reports all profile definitions
Command - pw: passwd Sets the PPP password
Command - RBDS report: Report RBDS Status
Command - RD asi: Report ASI Diagnostics
Command - RD ca: Conditional Access
Command - RD rf: Report Carrier Acquisition/Tracking Diagnostics
Command - RPATH relay: addr, Sets the address of the ReturnPath or mail proxy server.
Command - rpath sendrpt: [report_id] Sends the specified report to the ReturnPath server.
See addtional help for id values
report_id: 0 - Health & Status Report (default)
1 - Asset Inventory Report
2 - As-run Log Report (with delete)
3 - As-run Log Report (no delete)
5 - Operational Log Report (with delete)
6 - Operational Log Report (no delete)
7 - Return ShowShift Show Definitions
8 - Return ShowShift Shift Definitions
10 - Return OAR files
Command - RPATH send: [report_id] Sends the specified report to the ReturnPath server.
See addtional help for id values
report_id: 0 - Health & Status Report (default)
1 - Asset Inventory Report
2 - As-run Log Report (with delete)
3 - As-run Log Report (no delete)
5 - Operational Log Report (with delete)
6 - Operational Log Report (no delete)
7 - Return ShowShift Show Definitions
8 - Return ShowShift Shift Definitions
10 - Return OAR files
Command - rpath srvraddrbackup: addr, Sets the backup address of the ReturnPath or mail
proxy server.
Command - rpath srvraddr: addr, Sets the address of the ReturnPath or mail proxy server.
Command - RP ca: Conditional Access
Command - RP rec: Report Auto Recovery status
Command - RP rf: Report RF Parameters
Command - rrbds: Report RBDS Status
Command - R c: Report Carrier Status
Command - r groups: Report list of groups (not entire table)
Command - r g: [pagel] Report COMPEL Group Table (or page of it)