10 Installation
MAN0406 (Rev.9/7/2007)
Torque Mounting Hardware
Attach Backhoe Mounts to Backhoe
NOTE: Leave all hardware loose until backhoe has
been mounted to the tractor.
1. Attach right backhoe mount (3) and left backhoe
mount (4) to backhoe frame.
2. Secure into position using six (three per bracket)
cap screws (25), hardened flat washers (21), and
hex nuts (17).
3. Secure crossmember (10) to backhoe brackets
using four cap screws (18), hardened flat wash-
ers (22), and hex nuts (15).
3. 1013464 Right backhoe mount
4. 1013465 Left backhoe mount
10. 1012852 Crossmember, link 6500
15. 1093 1/2 NC Hex nut
17. 1450 3/4 NC Hex nut
(BH6500, BH7500 only)
18. 24576 1/2 NC x 1-3/4 Cap screw GR5
21. 57798 3/4 Hardened flat washer
22. 57816 1/2 Hardened flat washer
25 735 3/4 NC x 2 Cap screw GR5
Figure 15. Backhoe Mounts Installed
Figure 16. Backhoe Mount Installation
TORQUE SPECIFICATIONS
Ref Cap Screw Qty
Wrench
Size Required Torque
16 1/2 NC x 6 4 1/2" 85 lbs-ft (115 N-m)
18 1/2 NC x 1-3/4 4 1/2" 85 lbs-ft (115 N-m)
19 M16 x 2.0P x 70 mm 4 24 mm 125 lbs-ft (169 N-m)
20 M16 x 2.0P x 55 mm 4 24 mm 125 lbs-ft (169 N-m)
24 M16 x 2.0P x 40 mm 2 24 mm 125 lbs-ft (169 N-m)
26 5/8 NC x 2 8 15/16" 170 lbs-ft (230 N-m)
28 5/8 NC x 3 4 15/16" 170 lbs-ft (230 N-m)
(Rev. 5/2/2008)