Filter
Top Products
Installation 5
MAN0406 (Rev. 9/7/2007)
BACKHOE SUB-FRAME INSTALLATION
Tractor Preparation
■ Only use 1013460 4-Point Sub-Frame Mount-
ing Kit for mounting Woods BH70-X, BH80-X,
BH6500, BH7500 backhoe on New Holland
®
T2220, TC29DA, TC33DA, TC34DA tractors or
Case IH
®
DX34, Farmall
®
31, Farmall 35 tractors
equipped with Woods LS84, LC96, LC102, 1009
and 1012 loaders, New Holland 14LA loader or
Case IH L340 loader. Any other use or modifica-
tion of this mounting kit may result in serious
injury or death.
For installing this sub-frame, references to right, left,
forward and rearward directions are determined from
the operator’s position in the tractor seat.
Do not install 1013460 4-point sub-frame on a tractor
without a Woods or OEM loader mount attached.
Refer to the WOODS Backhoe Operator’s Manual for
backhoe assembly instructions.
Leave all hardware loose until sub-frame has been fit
up or otherwise specified in the instructions.
This mount can be installed on tractors equipped with
a New Holland mid-mount mower. Sub-frame can be
installed with mower attached but may be easier if
mower is removed from tractor.
1. Place jackstands under rear axle and remove
both rear tires.
2. Disconnect the anti-sway bars (Figure 1) from the
anti-sway brackets and remove front half. Store
front half of anti-sway bars for later use when
backhoe is removed.
3. Attach back half of anti-sway bars to the side of 3-
point arm to prevent them from pivoting during
backhoe operation.
4. Remove top link.
5. Remove ROPS hardware and spacer from both
sides of rear axle. See Figure 2.
6. With spacer removed, cut bottom flange off of
spacers. Spacer will be reused when sub-frame is
installed. Make sure cut is flush with side flanges.
See Figure 3.
Figure 1. Remove Front Half of Anti-Sway Link Bars
(Right Side Shown)
Figure 2. ROPS Hardware and Spacer - Right Side
Figure 3. Remove Flange
DP11
Flush
DP2
As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau-
lic hoses have been installed, please take a few minutes to complete the Sub-Frame
Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help
us continue to bring you quality products.
(Rev. 5/2/2008)