Filter
Top Products
Installation 13
MAN0406 (Rev. 9/7/2007)
Install Bulkhead Adapter
on Backhoe Mount
1. Attach bulkhead adapter (1) to crossmember
between backhoe brackets. Secure with nut sup-
plied with adapter.
2. Attach elbow (10) and female quick coupler (16)
to bulkhead adapter as shown in Figure 23.
3. Position elbow and quick coupler to point upward.
1. 1006144 Adapter, Bulkhead
3/8 NPTM x 3/4 JICM
10. 313017 Elbow, 3/8 NPTM x 3/8 NPTF 90°
16. 64299 Quick coupler, female
Figure 23. Bulkhead Adapter Installation - Backhoe
Install Hoses to Backhoe Valve
NOTE: Some hydraulic fittings supplied in this hose
kit may not be required for this application.
1. Attach hose (5) between the IN port on the back-
hoe valve and the bulkhead adapter on the cross-
member.
2. Attach male quick coupler (17) to hose (4).
3. Attach opposite end of hose (4) to the OUT port of
backhoe valve.
4. 1010924 Hose, 40" x 3/8 NPTM x 3/4 ORBM
5. 1013479 Hose, 10" x 3/4 JICF x 3/4 ORBM
17. 64300 Quick coupler, male
Figure 24. Backhoe Hose Connection
Install Rear Tires
When hydraulic hoses have been comply installed,
install rear tires.
NOTE: On tractors equipped with Turf tires (13.6-16)
adjust tire width to 46.6 inches center to center.
Figure 25. Rear Tire Spacing