Filter
Top Products
Installation 9
MAN0406 (Rev. 9/7/2007)
Install Cross Brace
1. Remove PTO shield.
2. Attach cross brace (7) to rear of tractor using two
cap screws (24) and hardened flat washers (23).
3. Attach to right and left tractor brackets using four
(two per side) cap screws (18), hardened flat
washers (22), and hex nuts (15).
4. Install PTO shield.
7. 1013474 Cross brace
15. 1093 1/2 NC Hex nut
18. 24576 1/2 NC x 1-3/4 Cap screw GR5
22. 57816 1/2 HArdened flat washer
23. 57817 5/8 Hardened flat washer
24. 64062 M16 x 2.0P x 40 mm Cap screw
Figure 11. Cross Brace Installed
Figure 12. Cross Brace Installation
Install Offset Bars
1. Place right offset bar (5) on the outside of right
tractor bracket.
2. Secure to front holes using two cap screws (26),
hardened flat washers (23), and hex nuts (27).
3. Secure to rear holes using two cap screws (28),
hardened flat washers (23), and hex nuts (27).
4. Repeat steps to install left offset bar (6).
5. 1013472 Right offset bar
6. 1013473 Left offset bar
23. 57817 5/8 Hardened flat washer
26. 902 5/8 NC x 2 Cap screw GR5
27. 230 5/8 NC hex nut
28. 34473 5/8 NC x 3 Cap screw GR5
Figure 13. Right Offset Bar Installed
Figure 14. Right Offset Bar Installation
23
24
18