Filter
Top Products
11
Advanced Functions. See page 16.
Locks out SET button and Advanced Func-
tions. See page 24.
Displays CEF, # CEF Recalc's, Average Depth
of Discharge, Deepest Discharge.
Resets amp hours and allows reset of every-
thing to factory default values. See page 22.
USING SET AND SEL BUTTONS
Pressing and holding the SET button for five seconds enters the Setup and
Advanced Functions modes. The word
SELSEL
SELSEL
SEL appears in the display, prompting you to press
the SEL button to choose what function you want to SELect.
PRESS BAT 1 OR BAT 2 TO PICK THE BATTERY YOU WISH TO SET UP.
Pressing SEL chooses a variable or function. The Setup mode always begins at
the
(Volts) function. Each press of the SEL button scrolls to the next item. When
a variable or function is selected, its corresponding light and present value is displayed. To
change a variable, press the SET button until the value appears that you wish. The order
displayed and brief descriptions are below.
LIGHT DESCRIPTION
Charged Voltage ( Battery must be above this voltage to be considered "full.")
Charged Current % (Charging current in amps must remain below this
percentage of battery capacity to be considered full.)
Battery Capacity in amp hours
Time interval over which current is averaged for Time Remaining function.
Each light will come on in sequence.
Now let's SET UP your system. We'll explain Charged
Voltage, Charged Current Percentage, Battery Capacity, Time
of Operation Remaining averaging, and set an appropriate rate
compensation (Peukert) exponent.