Filter
Top Products
WebLink Set/Get/Do Commands
weblink.ip.conn[1|2].authentication.add
68
P1058563-003 10/31/13
weblink.ip.conn[1|2].authentication.add
Description This command allows the user to add a single server/username/password
triplet into the list of authentication entries.
When the printer attempts to connect to the server (url specified in
weblink.ip.conn[1|2].location) the server may require HTTP authentication (e.g. digest,
basic, DNS, etc.). There may be multiple authentication requests along the route to the
destination (e.g. a local server first requires HTTP authentication as well as on the remote
server).
For each HTTP authentication request received while attempting to connect, the printer will
enumerate the authentication entries and attempt to satisfy the request with the
username/password pair provided for the respective server. The server name in the entry is
what determines which username/password pair should be used for which authentication
request. Both DNS names and IP addresses are acceptable. The server, username, and
password are separated by a single space (not a tab or other white space character). The server
name is the only required field. If no username is supplied, but a password is, there must be
two spaces between the server and the password fields. If there is a username but no password,
or simply just the servername, no space is required at the end of the entry.
If the command is changed when the connection is enabled (
weblink.enableissetto
"on"
), it will not take effect until the connection is disabled and then re-enabled.
^JUF,^JUS,^JUN,^JUA, and device.restore_defaults do not have any affect on this
setting.
Supported Devices
• iMZ 220™, iMZ 320™
• QLn220™, QLn320™, QLn420™
• ZT210™, ZT220™, ZT230™
Type
setvar
Important •
This setting only be changed when weblink.enable is set to "off".