ESP 19
3-4
10. During floor travel and lift operations, the alarm beeper should sound. If the
alarm beeper does not work properly, do not operate the lift vehicle.
11. During lift platform descent, the amber caution light should blink on and off. If
the caution light does not blink on and off, do not use the lift vehicle.
12. If any equipment motion continues after the pushbutton, joystick, or selector
switch is released, press the
EMERGENCY STOP pushbutton, Figure 3-2. All
equipment motion should stop immediately.
13. At the end of each workday and whenever a low battery alarm sounds, transport
the lift vehicle to the recharge site and plug in the charge cord. Verify that the
ON-CHARGING indicator lights up on the battery charger.
NOTE: For more information on battery charging operations, refer to the bat-
tery charging procedure in paragraph 4-4.
14. To shut down the equipment, turn the
UPPER CONTROL/OFF/LOWER CONTROL key
switch and the
BATTERY ON/OFF switch to OFF. Remove the key to prevent unau-
thorized equipment operation.
