A SERVICE OF

logo

Using Short Tear-Off
3..
Press the TEAR OFF button to enter tear-off mode. The
TEAR OFF
light goes on and the printer feeds the paper’s perforation to the
printer’s tear-off edge.
4.
If you need to adjust the position of the perforation so that it
meets the printer’s tear-off edge, use the
MICRO
FEED
buttons.
You can press the top or bottom MICRO
FEED
button once to
feed the paper forward or backward
l/216&
of an
down the button to feed the paper continuously.
inch, or hold
Note: You can reset the tear-off position only when you are in
tear-off mode (after you have pressed the TEAR OFF button once
and the TEAR OFF light is on).
Using the Printer
3-41