Printing
Problem
Solution
The printing position is
incorrect (continued).
In BASIC, enter one of the following
statements:
WIDTH
LPRINT
255
LDTH
“LPTl:“,
255
If the printer still does not print properly,
set the right margin to the maximum setting
using
ESC
Q.
All the text is printed
on the same line.
The printer
inserts
extra blank lines
between lines of text.
The page length does
not match the
length
of the paper.
A line feed signal is not being sent at the
end of each line. Turn on DIP switch
2-4
so that the printer adds a line feed code to
each carriage return sent by the application
program. See page
3-15.
Extra line feed signals are being sent. Turn
off DIP switch
2-4.
See page
3-15.
The page length may be set incorrectly.
Check your application program’s page
length setting and change it if necessary.
You can also turn off DIP switch
3-2
to set
the page length to
11
inches
(279.4
mm) or
turn on the switch to set the
page length to
12
inches
(304.8
mm). See page
3-17.
If
your application program can send control
codes to the printer, you can set the page
size using
ESC
C
or
ESC
C
0.
7-10
Troubleshooting
