Pull
Tractor
6.
Open the paper bail using the tab on its right side. Then tilt the
pull tractor back until its rear latches click into place over the
printer’s rear mounting pins.
7.
Close the paper bail and then close the top cover.
Paper handling
If you are using labels or multi-part forms with more than four
parts including the original, use the pull tractor with the built-in
front tractor.
You can switch between the front and rear tractors at any time
when you are using the pull
tractor. Just press the FRONT/REAR
button and then
use the
FORM
FEED
button to
feed
the paper the
additional distance to the
pull tractor. (Labels require special
handling. gee
the’section
on labels in Chapter 2.)
WARNING: The short tear-off feature does not work when
the pull tractor is installed. To remove a document, press
the FORM FEED button to advance the paper to a point
where you can tear it off.
Using the Printer Options
5-5
