Power Supply
Problem
Solution
Power is not being
supplied to the
printer.
The
POWER
light does
not go on.
The
POWER
light
comes on
briefly
and
then goes
0%.
The
Zight
stays ofi after
you turn
the
printer
off and then on
again.
The power cable may not be fully plugged
into the printer or the electrical outlet.
Turn
off the printer and see that the cable
is fully plugged into the printer and the
electrical outlet.
The power switch is off.
Turn
on the
switch.
The electrical outlet may not be supplying
power. Check if an outside switch or
automatic timer controls the
electrical
outlet. If so, use a different outlet.
The electrical outlet may not work. Plug
another electrical device into the outlet to
check whether the outlet works.
The voltage
supplied
by the electrical outlet
may
not be correct for your printer. Check
the label on the printer’s rear panel to see if
the printer’s
voltage rating matches that of
your electrical outlet. If the voltages do not
match, unplug the printer and contact your
Epson dealer. Do not reconnect the power
cable to
an electrical outlet. See page
1-13.
Troubleshooting
7-3
