Chapter 3 System Configuration 33
a. To set the Service Processor host name:
where xscfu can be xscf#0 (XSCF Unit 0) or xscf#1 (XSCF Unit 1 in a high-
end server); hostname is the host name to be set for the specified Service
Processor (XSCF Unit).
b. To set the Service Processor domain name:
3. To verify the operation, type the showhostname command.
where -a displays the host names for all XSCF Units, and xscfu displays
information for a specific XSCF Unit, either xscf#0 or xscf#1.
▼ To Set the Service Processor’s DNS Name Server
1. Log in to the XSCF console with platadm privileges.
2. Type the setnameserver command, followed by one or more IP addresses
separated by a comma:
3. To verify the operation, type the shownameserver command.
▼ To Enable or Disable Use of an LDAP Server for
Authentication and Privilege Lookup
1. Log in to the XSCF console with useradm privileges.
XSCF> sethostname xscfu hostname
XSCF> sethostname -d domainname
XSCF> showhostname -a | xscfu
XSCF> setnameserver ip_address
XSCF> shownameserver
