44 SPARC Enterprise Mx000 Servers Administration Guide • November 2007
3. Type the setssh command:
where function is either enable or disable. You must generate a host public key
to use SSH.
▼ To Generate a Host Public Key for SSH Service
1. Log in to the XSCF console with platadm privileges.
2. Type the setssh command:
For additional options with the setssh command, including information on adding
or deleting user public keys, refer to the setssh(8) man page or to the SPARC
Enterprise M4000/M5000/M8000/M9000 Servers XSCF User’s Guide.
▼ To Set the Altitude on the Service Processor
1. Log in to the XSCF console with fieldeng privileges.
2. Type the setaltitude command:
where
value is a unit of meters. The unit of meters is rounded off to the nearest
hundred meters.
3. To verify the operation, type the showaltitude command.
XSCF> setssh -c function
XSCF> setssh -c genhostkey
XSCF>
setaltitude -s altitude=value
