1.1 General Features
Feature Manual 29
• SLT Hold Mode
It is possible to specify how calls are held and transferred with an SLT when the Recall/hookswitch is
pressed for less than 1000 ms.
The following methods ( [104] SLT Hold Mode) are available:
In some cases, a call is not disconnected when an SLT user goes on-hook. Instead, the call is
mistakenly placed on hold. After a specified time expires, the Hold Recall tone is heard. When the SLT
user answers this, the user hears a cyclic tone (like a reorder tone). To avoid this problem, select "Hold-
2" or "Hold-3". In either of these modes, all calls are disconnected when going on-hook, unless the Call
Hold feature number is entered after pressing the Recall/hookswitch.
• Pressing the HOLD button multiple times alternates between General and Exclusive Call Hold.
Programming Manual References
[PT Programming]
[104] SLT Hold Mode
[111] Music on Hold
[200] Hold Recall Time
[PC Programming]
9.1.2 Main [1-2]—Music on Hold
9.1.7 Timers [1-6]—Recall Time—Call Hold
9.1.11 Detail [1-10]—Single Line Telephone—Hold Mode
Feature Manual References
1.1.19 Call Park
1.1.85 Music on Hold
2.2.1 Tones/Ring Tones
Operating Manual References
1.3.15 Call Hold
Mode Hold Transfer to Extension
Hold-1
Pressing the Recall/hookswitch
+
Going on-hook
Pressing the Recall/hookswitch
+
Extension No.
Hold-2
Pressing the Recall/hookswitch
+
Call Hold Feature No.
+
Going on-hook
Pressing the Recall/hookswitch
+
Extension No.
Hold-3
Pressing the Recall/hookswitch
+
Call Hold Feature No.
+
Going on-hook
Pressing the Recall/hookswitch
+
Call Hold Feature No.
+
Extension No.
