User’s Manual of WSD-800 / WGSD-910/WGSD-1022C
-20-
show qos map dot1p-cos-map Show qos map cos-queue-map
show qos map mac-cos-map Show qos map mac-cos-map
show qos map port-cos-map Show each port's cos
show qos map vlan-cos-map Show qos map vlan-cos-map
show qos queue egress-policy Show qos queue egress-policy
show radius Show radius information
show security MAC-aging Show MAC aging time
show security filter-MAC Show MAC filter entry
show security mac-learning Show port security status
show security static-MAC Show static mac table information
show snmp Show snmp information
show snmp rmon Show snmp rmon state
show spantree Show spanning tree information
show syntax Show basic help infomation
show system Show system information
show trunk Show trunk information
show version Get last software version
show vlan Show vlan information
show vlan type Show current vlan type
3.5.2 Privileged Command
To access to the second level, enter the “enable” command in the first level. The sysem then prompt for a
password. Please enter “admin” for the password.
The promt then changes to “Switch\enable>”. Entering a question mark "?" at the prompt displays the list of
commands available for command mode.
3.5.2.1 Clear command
Clear command is to clear the parameter. The follow table lists the clear commands and the equivalent usages.
Command Description
clear channel Clear member from channel
clear dot1x local-userInfo Clear igmp-snooping group policy
clear igmp-snooping policy deny Clear igmp snooping policy deny
clear mirror monitored-port egress Clear egress monitored port for mirror
clear mirror monitored-port ingress Clear ingress monitored port for mirror
clear multicast router Clear router port
clear port counters Clear port statistics counter
clear port rate-shaping Clear rate-shaping of all ports
clear port spantree portcost Restore spanning tree port cost to default value
