Filter
Top Products
14 78-8135-4385-3-A
13.0 Boot Placement for 900 micron Fiber
13.1 Remove connector from the load adapter and slide the
boot over connector until fully seated.
IMPORTANT: Remove connector gently so that you
don’t break the fiber. If connector sticks to the sides of
the load adapter when trying to remove, re-heat the
connector slightly until connector can be removed from
the load adapter. Use the cleaning pin furnished in the
kit to scrape the adhesive out of the load adapter hole
before proceeding with next connector.
14.0 Crimping and Boot Placement for
1.6 – 2.0 mm Jacketed Fiber
14.1 Slide crimp/shrink tube down and over aramid yarn.
14.2 Remove the connector from the load adapter.