Filter
Top Products
78-8135-4385-3-A 19
17.7 Clean the flat side of the polishing jig with a lint-free
cloth moistened with isopropyl alcohol.
17.8 Place the polishing jig assembly on the lapping film.
17.9 Place the ferrule in the polishing jig aligning the latch
side of the connector with the slot until it stops.
Note: The ferrule must be able to slide freely inside the hole
in the polishing jig. If not, the ferrule may have adhesive
on it which needs to be cleaned off with alcohol and a lint-
free cloth.
17.10 Insert the polishing weight into the adapter/jig
assembly covering the connector.
Note: The weight should pop up slightly (1/16") when
holding the jig flat against the lapping film, indicating that
the ferrule can move freely.