Filter
Top Products
20 78-8135-4385-3-A
17.11 Polish 10 figure-eight strokes or until bead of adhesive
is no longer visible.
Note: Do not hold polishing jig assembly by the weight
when polishing. Hold only by the textured polishing
adapter.
Note: Because bead is 3 to 4 times smaller than classic hot
melt connectors you will not feel the bead of adhesive being
removed as you polish.
IMPORTANT: Make sure that polishing jig stays flat on
lapping film at all times
17.12 After bead of adhesive is no longer visible, polish an
additional 5 strokes.
17.13 Remove the connector from the polishing jig assembly
and clean the connector endface with a lint-free cloth
moistened with isopropyl alcohol.
17.14 Inspect the connector endface with the 200X
Westover
™
Scientific fiber view scope. Use the thumb
toggle switch to activate the light onto the fiber end
face. There are two light settings—coaxial and oblique
angle lighting.