Filter
Top Products
24
There are three possible hookup errors: 1) the
fault is greater than 20 MΩ, 2) the Red/Green
strap is bad, 3) the Red/Yellow strap is bad.
The screen will show the combination of errors
that has been detected. Correct the errors and
press the [Enter] key to repeat the hookup test.
If no errors in the hook-up are detected, the
965DSP-B will go directly from the hook-up
screen to the following results screen.
If the Yield Sign shows beside the results,
this indicates a possible inaccuracy in the results
(due to noise or other line conditions).
Press [Tab] to show readings in Ohms instead of
distance. Press [Enter] to repeat the fault locate
using the same Distance to Strap. Press [Setup]
to go to the RFL setup screen.