Filter
Top Products
29-EN
01GB05IVA-W502E.fm
ALPINE IVA-W502E 68-12118Z56-A (EN)
This function can help restrict the viewing of movies to children of
appropriate age levels only.
Setting item: PARENTAL
Setting content: INPUT
• When the settings are changed, the old settings are overwritten.
Make a note of the current settings before making changes. The
memory is cleared when the vehicle’s battery is disconnected.
• On unrated DVDs, playback will not be restricted even if the rating
level is set.
• If you want to play back DVD software with the parental lock feature
and its use is currently restricted, change the rating level and the
country number in order to play back the DVD.
• Once set, this rating level remains in memory until changed. To
enable playback of discs of higher rating levels or to cancel the
parental lock, the setting must be changed.
• Not all DVDs provide a Parental Lock feature. If you are unsure
about a DVD, play it first to confirm. Do not leave DVDs accessible
to young children for whom you deem them inappropriate.
1 Touch [INPUT].
The numeric keypad screen is displayed.
2 Touch the numeric keypad to input a 4-digit password.
The initial number is 1111. Input number are displayed
as “*”.
3 Touch [ENT] to memorize the number.
The PARENTAL screen appears.
Set the rating level of PARENTAL
4 Touch [] of PARENTAL to turn on.
5 Touch [] or [] of PARENTAL LEVEL to select the rating
level (1 to 8).
Select “OFF” to cancel the parental lock or if you do not
want to set a rating level. The smaller the number, the
higher the rating level.
6 Touch [] to return to the previous screen.
Changing the password
4 Touch [INPUT] of PASSWORD CHANGE.
The numeric keypad screen is displayed.
5 Touch the input screen to enter a new 4-digit password.
• Keep a note of the number somewhere safe in case you should
forget it.
6 Touch [ENT] to memorize the number.
7 Touch [] to return to the previous screen.
Use the following procedure to set the digital audio signal output from
the IVA-W502E.
Setting item: DIGITAL OUT MODE
Setting contents: AUTO / LPCM
Setting the Rating Level (Parental Lock)
Changing the rating level temporarily
Some discs may request that you change the rating level set in
the default settings during playback. In this case, the message
appears on the monitor screen “PARENTAL LEVEL CHANGE OK?
[YES] [NO].”
If this screen appears, change the level as follows:
• To change parental level and play, touch [YES].
When [YES] is touched, the numeric keypad input screen is
displayed. Input the 4-digit password in “Setting the Rating Level
(Parental Lock)” you set, then touch [ENT].
• To play without changing the parental level, touch [NO].
(When [NO] is touched, playback will be at the parental level set
in “Setting the Rating Level (Parental Lock).”)
Changing the Digital Output Setting
AUTO: The digital output is switched automatically according
to the type of audio signals being played.
Be sure to select “AUTO” when you want to connect a
digital audio processor and play Dolby Digital audio.
“AUTO” is the factory setting.
LPCM: The audio signals recorded on the disc are converted
to 48 kHz/16 bit (for DVDs) or 44.1 kHz (for Video CDs
and CDs) linear PCM audio signals for output.
01GB00IVA-W502E.book Page 29 Wednesday, February 20, 2008 4:12 PM