Filter
Top Products
46-EN
01GB06IVA-W502E.fm
ALPINE IVA-W502E 68-12118Z56-A (EN)
The output when playing discs recorded in linear PCM can be set to 2 or
3 channels.
Setting item: PCM MODE
Touch [] or [] of PCM MODE to select 2CH or 3CH.
• This adjustment is ineffective when the speaker is set CENTER to
OFF in “Setting the Speakers” (page 44).
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Touch [MEMORY] on the A.PROCESSOR list
display.
2
Within 5 seconds, touch any one of the preset
buttons [P.SET 1] through [P.SET 6] on the
A.PROCESSOR list screen.
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
Calling up the Preset Memory
Touch any one of the preset buttons [P.SET 1] through
[P.SET 6] on the A.PROCESSOR list display to select
the preset memory.
• It takes a few moments to call up the preset memory.
Alpine introduces IMPRINT - the world’s first technology that
thoroughly eliminates in-car acoustic problems that normally degrade
sound quality, which enables us to experience music the way the artist
intended, refer to “About IMPRINT” (page 52).
When the IMPRINT audio processor (PXA-H100) (sold separately) is
connected to this unit, MultEQ and the following sound adjustment can
be performed.
Changing MultEQ mode
MultEQ, developed by Audyssey Labs, automatically corrects the audio
for the listening environment. The system is optimized for selected
positions in the vehicle. To accomplish this, MultEQ must take
measurements of the vehicles response characteristics. For details on the
set up procedure, consult your authorized Alpine dealer.
1
Press IMPRINT of the unit, the MultEQ mode
selection screen will be displayed.
2
Touch [] or [] to change the setting.
Setting contents: OFF / CURVE 1 / CURVE 2
• The Curve mode can be selected only when curve 1 and curve 2 are
stored.
•
When MultEQ is set to CURVE 1 or CURVE 2, MEDIA XPANDER, X-
OVER, T.CORR, SUBWOOFER PHASE, SUBWOOFER SYSTEM,
SUBWOOFER CHANNEL, TW SETUP, P-EQ, G-EQ and F-EQ can
not be adjusted.
Linear PCM Setting
2CH: 2ch output (L/R)
3CH: 3ch output (L/R/CENTER)
IMPRINT Operation
(Optional)
The Parking Brake must be engaged to access the IMPRINT
mode screen. Attempting to access this screen while driving will
display the warning-CAN’T OPERATE WHILE DRIVING.
OFF: Adjusting the audio settings manually to create your
own preference.
CURVE1/
CURVE2: Correcting the audio for the listening environment
automatically.
01GB00IVA-W502E.book Page 46 Wednesday, February 20, 2008 4:12 PM