Filter
Top Products
DVr stAtioN
16
USER MANUAL - version 1
2
nd
Test: changing channels on your tuner
After you select “Yes” at the end of the 1
st
test, the following screen appears. It allows you to correctly set the
parameters so that the ARCHOS can change channels on your tuner (for a scheduled recording).
For the “Channel” parameter, select the highest channel that is currently memorized on your tuner.
Select the “
Test channel select” button. Make sure that your tuner is on. Your ARCHOS device will then
attempt to switch your tuner to the selected channel. After a few seconds, your ARCHOS will ask you if the
device responded correctly:
If this worked, select “
Yes”.
If this did not work, select “
No, try next option”. Your device will try again to switch your tuner to the
selected channel, using a different option*. Repeat this operation until it works.
*Here is a description of the different parameters it will use. These parameters can be set manually as well:
“Key Delay”:
delay between the emission of each digit of a channel (“
Short
”, “
Normal
”, “
Long
”).
“Key: Enter”:
Set to “
On
” if normally, you have to press an “
OK
” button on your turner’s remote control
after you enter the channel number. Example: If you normally press 1, 3, “
OK
” to access channel 13, then
this parameter is set to “
On
”.
“Key: -/--”:
Set to “
On
” if normally, you need to press a special key on your tuner’s remote control before
entering a channel with several digit numbers (that is to say a channel greater than 9). This key is often
represented with this symbol: “
”.
“Switches on with”:
see below.
“Time until video”:
see below.
If the ARCHOS did not manage to switch your tuner to the selected channel, you can try using different ON/OFF codes
(see: 1
st
Test: turning your tuner off) and do the 2
nd
test again.
After you selected “Yes” at the end of the 2
nd
step, the following screen appears. You will have to set these
two parameters:
1.
2.
-
-
-
-
-
3.