Filter
Top Products
Using System Designer
FPSLIC STK594 User Guide 4-13
2819A–FPSLI–07/02
Figure 4-18.
In-System Programming
3. Place the Programming switch in the
PROG
position.
4. Using a 10-wire ribbon cable from the STK500, connect
PORTD
to the
LEDS.
5. Using a 2-wire cable from the STK500, connect
SW0
and
SW1
to FPSLIC pins
177 and 178, respectively.
6. Connect the Power Supply from an AC outlet to the power connector on the
STK500 development board.
7. Turn on the STK500.
Note:
Prior to providing power to the STK500 development board it is necessary to
adjust the VTARGET supplied by the STK500 to the STK594, for more informa-
tion on this adjustment please refer to Section 2.1.1.
4.10.2 Software Setup The CPS utility allows for the programming, reading, and verification of data. CPS sup-
ports Atmel’s AT17F, ATFS and AT17LV series of configuration memories.
1. Press the
CPS
button, see Figure 4-19.