63
System modulator
If you have an audio setup, such as a BeoLink
Active/Passive, and you choose to set up a
non-linkable television in the same room, you
must set the system modulator to ON. The
factory setting is OFF, which must be used if
you are using a linkable Bang & Olufsen
television.
To switch on the system modulator …
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu
and press
to highlight TUNING.
> Press GO to bring up the TV TUNING menu,
and press
to highlight LINK FREQUENCY.
> Press
twice, followed by GO. The
MODULATOR SETUP menu appears.
> Press
or to reveal ON.
> Press GO to store the setting, or …
> … press EXIT to leave all menus without
storing.
Link frequency
If, for example, a TV program in your area is
broadcasted on the same frequency as the
BeoLink system uses, 599 MHz, you must tune
the system modulator to an unoccupied
frequency. When you change the link
frequency in the main room system, make
sure that the link frequency in the link room
system corresponds to it.
To change the link frequency …
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu
and press to highlight TUNING.
> Press GO to bring up the TV TUNING menu and
press
to highlight LINK FREQUENCY.
> Press GO to bring up the LINK FREQUENCY
menu. FREQUENCY is already highlighted.
> Press or to find an unused frequency.
> Press GO to store the setting, or …
> … press EXIT to leave all menus without
storing.
