Bang & Olufsen 8 CRT Television User Manual


 
17
One remote control for both televisions
Two televisions in the same room
If you have placed your BeoVision 8
in a room where you already have a
Bang & Olufsen television, and
commands from Beo4 can be
received by both televisions, you
must change the option setting of
BeoVision 8. This prevents
simultaneous activation of both
televisions.
Foryourtelevisiontofunctionproperly,itis
essentialthatthetelevisionissettothe
correctOption:
To set your television for Option 4 …
>Whileholdingthe•buttononBeo4,pressLIST.
> Let go of both buttons.
> Press LIST repeatedly to display OPTION? on
Beo4 and press GO.
> Press LIST repeatedly to display V.OPT on Beo4
and press 4.
Operate your television in Option 4 …
Normally, you can activate a source, such as TV,
simply by pressing the relevant source button on
Beo4. However, when you set your television to
Option 4, you must do the following:
> Press LIST repeatedly until LINK* is shown in
the Beo4 display.
> Press a source button, such as TV.
*In order to display LINK on Beo4, you must add it to
the Beo4 list of functions. For further information,
refer to the Guide enclosed with Beo4.
In order to use teletext on a television you have set
to Option 4, you must set up Beo4 to ‘VIDEO 3’,
but this limits the Beo4 functions that can be used
with televisions set to other Options. For further
information, refer to the Guide enclosed with
Beo4.
BeoVision 8
Option 4
TV
LIST
LINK
TV