Bang & Olufsen 8 CRT Television User Manual


 
46
Set up the television
For information about how to fasten
and run the cables on the rear of the
television, refer to this page.
For further information about the
connection panels, refer to page 50.
Avoidplacingthetelevisionindirectsunlight
ordirectarticiallight,suchasaspotlight,as
thismayreducethesensitivityoftheremote
controlreceiver.Alsoifthescreenisover-
heated,blackspotsmayappearinthepicture.
Thesespotsdisappearagain,oncethetele-
visioncoolsdowntonormaltemperature.
Toavoidinjury,useBang&Olufsenapproved
standsorwallbracketsonly.
Makesurethatthetelevisionissetup,placed
andconnectedinaccordancewiththese
instructions.
Thetelevisionisdevelopedforindoorusein
dry,domesticenvironmentsonly.Usewithin
atemperaturerangeof10–40°C(50–105°F).
Donotplaceanyitemsontopofthetele-
vision.
Donotattempttoopenthetelevision.Leave
suchoperationstoqualiedservicepersonnel.
Thetelevisionwasdesignedtobeleftinstandby
modewhennotinuse.Therefore,tofacilitate
remotecontroloperation,itisessentialthat
youdonotdisconnectitfromthemains.The
televisioncanonlybeswitchedoffcompletely,
ifyoudisconnectitfromthemains.
Place the television on a firm and stable surface.
The standard placement allows you to tilt the tele-
vision, for example to facilitate viewing at a low
placement. To tilt the television pull at the bottom
of the television
If you are going to place the television on either the
floor stand or the wall bracket, the two standard
‘feet’ must be removed from the tele vision. Follow
the instructions in the Guide enclosed with these
optional accessories.
Handling your television