Filter
Top Products
19-23
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Chapter 19 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
Using Workgroup Bridges in a Lightweight Environment
Enabling VideoStream Support on Workgroup Bridges
VideoStream improves the reliability of an IP multicast stream by converting the multicast frame, over
the air, to a unicast frame. Cisco IOS Releases 15.2(2)JA and later provide VideoStream support for
wired devices connected to workgroup bridges. For access points running release 15.2(2)JA and later,
the workgroup bridge is added to the wireless LAN controller (WLC) multicast table, and the workgroup
bridge converts the VideoStream unicast frame into an Ethernet multicast frame and sends it out to its
wired clients.
Enter this command on the WLC to enable VideoStream for workgroup bridges:
config media-stream wired-client enable