Filter
Top Products
OPERATIONS
40 VXZ768R
English
3. Press the “ ” button to go to the option list
and press “ ” or “ ” buttons to select the
setting.
You can select the settings as shown in the
following table.
Asterisk (∗) indicates the factory default setting.
4. Press the [ENT] button.
5. Repeat steps 2 to 4 to turn on/off each
speaker.
Adjusting the speaker gain
• The factory default setting is “0 dB”.
1. Following the steps 1 to 3 in “Selecting the
monitor menu”, select “SP-GAIN” from
“AUDIO SETUP”.
2. Press the “ ” button to display the
SP-GAIN screen.
3. Press “ ” or “ ” buttons to select the
speaker.
Each time you press the buttons, you can
switch among speakers.
The test tone is output from the speaker you
select.
4. Press “ ” button to go to the right pane.
5. Press “ ” or “ ” buttons to adjust the
speaker gain. The gain level ranges from
“-6dB” to “+6dB”.
6. Press the “ ” button to go back to the left
pane.
7. Repeat steps 3 to 5 to adjust the each
speaker gain.
Note:
•
The test tone will not be output when DVD or CD
is being played with mute ON.
In that case, press the [MUTE] button on the
remote control unit to cancel the mute, or adjust
the volume.
FRONT-SP
(Front speaker)
LARGE
SMALL ∗
CENTER-SP
(Center speaker)
SMALL ∗
OFF
SRD-SP
(Surround speaker)
LARGE ∗
SMALL
OFF
SUB-WOOFER
(Subwoofer)
ON ∗
OFF
AUDIO SETUP
DELAY >
SP-GAIN >
SPEAKER-SEL >
PRESS RIGHT TO SELECT
DRC OFF
Dolby PL ON
FRONT L
CENTER
FRONT R
SRD L
SRD R
SUB-WOOFER
SP-GAIN
FRONT R 0dB
CENTE R 0dB
FRONT L 0dB
PRESS RIGHT TO SELECT
SRD L 0dB
SRD R 0dB
SUB-WOOFER 0dB
VXZ768R.book Page 40 Tuesday, December 27, 2005 10:08 PM