Clover Electronics CDR0430 DVR User Manual


 
Contents
- 31 -
Front Panel
Remote
5-6.
Recording
5-6-1. Manual Recording
The user can manually start recording the video
footage by pressing the buttons shown.
The Manual Recording will start recording only if the Sensor, Motion Detect
and Record Schedule is not set. The icons are shown below.
5-6-2. Automatic Recording
To enable recoding when the Sensor / Motion Detector / Schedule Recording is
triggered, the user must press the Record button after setting the functions
mentioned above.
If the Record button is pressed while any of the three functions are enabled,
there will be no recorded data unless the sensor is triggered, motion is detected
or if there is a Schedule Recording presently set.
Ú For more information please refer to Chapter 6-3. Record Setup, 6-4.
Sensor and 6-5. Motion Detection
Sensor / Motion / Schedule