Filter
Top Products
Waterproof Wireless Handheld Remote Crestron WPR-48
ID and IR ID settings are 10. The RF/IR ID of the unit and the RF/IR ID specified
for it in the SIMPL Windows program must match. There are 256 possible two-digit
hexadecimal codes ranging from 00 to FF.
Refer to the note on page 18 for a
definition of Viewport.
To configure the WPR-48 through Viewport, the following items are required
• PC running Crestron’s Viewport utility, version 3.99.01 or later.
• An RS-232 cable (RJ-11 – DB-9) such as the Crestron STCP-502 (not
supplied) to connect the WPR-DS to the serial port of the PC. This
connection can also be made with a modular RJ-11 cable and a DB9F to
RJ-11 adapter. (Refer to the following illustration.)
NOTE: Check the SIMPL Windows gateway models prior to setting the RF ID or
IR ID. Some gateway models do not support ID “00” or “FF.”
NOTE: If the battery in the WPR-48 has become fully discharged, it will require
approximately five minutes of recharging before the unit can be reconfigured.
With the WPR-48 inserted in its docking station, complete the following procedures.
1. Verify that communications with the PC are established, as specified in
“Communication Settings” on page 18.
2. Open the Crestron Viewport, and from the menu bar, select Functions |
Configure WPR-48 as shown in the following illustration.
NOTE: While configuring the WPR-48, do not remove the WPR-48 from the
docking station until you have exited the dialog by clicking on Exit.
6 • Waterproof Wireless Handheld Remote: WPR-48 Operations Guide – DOC. 6254A