Filter
Top Products
Crestron WPR-48 Waterproof Wireless Handheld Remote
Industry Compliance
As of the date of manufacture, this unit has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. The equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Setup
Applying Power
Power for the WPR-48 is provided by the built-in, rechargeable 3.6 VDC lithium-ion
battery. (The unit is shipped with the battery charged.) The battery is recharged when
the WPR-48 is placed in the companion docking station (WPR-DS). Note that the
docking station is also used during configuration procedures and when uploading
new firmware to the WPR-48. When the docking station is being used for
configuration or firmware functions, the recharge circuits are automatically turned
off.
Configuring the WPR-48
The WPR-48 can be configured to transmit either RF or IR signals. (By default, the
units are shipped as RF devices.) Every WPR-48 transmitter communicating with a
Cresnet system via RF requires a unique RF ID to secure RF communications.
Similarly, every WPR-48 transmitter communicating with a Cresnet system via IR
signals requires a unique IR ID to secure IR communications. The unit’s default RF
Operations Guide – DOC. 6254A Waterproof Wireless Handheld Remote: WPR-48 • 5