Filter
Top Products
Waterproof Wireless Handheld Remote Crestron WPR-48
WPR-48 Physical Views.
Connectors
The only connectors on the WPR-48 are the two contacts on the back panel. These
contacts are used for charging the long-life lithium-ion battery when the unit is
placed in the WPR-DS docking station. These contacts are also used when
configuring the unit and when firmware is uploaded via the docking station.
NOTE: During configuration and when firmware is being uploaded, the charging
circuits in the docking station are automatically disconnected.
Controls
The WPR-48 has nine three-position buttons, which can be configured, using the
Crestron Viewport, for 9-, 18-, 27-, or 48-function operation. Actual button functions
are defined in the SIMPL Windows program, based on the application of the unit
within the Cresnet system.
Indicators
The only indicators on the hand-held WPR-48 are the four LEDs on the face of the
unit, above the button function windows. The B LED (red) blinks if the battery
charge is low; the T LED (red) illuminates when the WPR-48 is transmitting. The
operation of the J LED (red) and the K LED (red) depends on the unit’s
configuration. In a 48-button configuration, the J LED indicates that the unit is
transmitting ‘page 1’ functions; the K LED indicates that the unit is transmitting
‘page 2’ functions. In the 9-, 18-, and 27-button configurations, there are no ‘page’
functions. If the configuration is set up to allow key presses to change the unit’s RF
or IR ID, these two LEDs illuminate simultaneously during ID reprogramming (refer
to “Setting RF/IR ID via Button Presses” on page 9 for details).
4 • Waterproof Wireless Handheld Remote: WPR-48 Operations Guide – DOC. 6254A