Filter
Top Products
23
4.3.3 Time
Step 1: Enter into system configurationrecord configuration time; refer to Fig 4-13:
Fig 4-13 Record Configuration-Time
Pre-alarm record time: set the record time before event happen i.e. record time before motion detection or
sensor alarm is triggered.
Post-alarm record: set the post recording time after the alarm is finished, five options: 10s, 15s, 20s, 30s and
60seconds.
Expire time: the hold time of saved records. When the set date has passed, the record files will be deleted
automatically.
Step 2: User can setup all channels with same parameters, checkmark “all”, then to do relevant setup.
Step 3: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to
exit current interface.
4.3.4 Recycle Record
Step 1: Enter into system configurationrecord configurationrecycle record;
Step 2: Checkmark recycle record, the recycle record function will be enabled, it will overwrite the earlier recorded
files and keep recoding when HDD is full; if not enables the DVR will stop recording when HDD is full.
Step 3: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to
exit current interface.