Filter
Top Products
12
© 2006 directed electronics.
LED tester, turn the switch to the parking light position. The
LED tester will illuminate Green. While testing the suspected
wire, run the dash dimmer light control up and down — the
voltage should NOT vary (LED tester illumination). If the
voltage does vary, continue probing to find the correct wire.
Once you have identified the correct wire, solder the WHITE
(H1/9) wire on the 14-pin harness to it and wrap the connection
with electrical tape.
step 4 (optional)
Starter Kill or Expansion Item Add-On Output
The ORANGE (H1/8) wire (Ground-When-Armed) can be used
to control an optional starter kill relay or expansion item. This wire
supplies a -500mA output only when the doors are locked using the
remote. Refer to TechTips on www.readyremote.com or contact
READY REMOTE technical Support for details and additional
parts required.
Refer to the end of this manual for the Emergency Override
Procedure (if you lose your remote) to disable the optional starter
➜
G21994_04-06.qxd 12/11/06 3:36 PM Page 12