Filter
Top Products
32
© 2006 directed electronics.
1.
FFuussee..
Remove and re-insert fuse into main fuse holder.
2.
KKeeyy..
Turn the ignition to the ON position.
The parking lights will immediately turn on to
indicate transmitter learn mode. After 5-
seconds the parking lights will turn off and then
turn back on to indicate ready to learn mode.
3.
PPrrooggrraamm..
Within 10-seconds, press and hold the
button on the transmitter, until the parking lights turn off
and then back on. Now release the button. Repeat
this step within 10-seconds of programming a transmitter to
program additional transmitters to your system.
4.
EExxiitt LLeeaarrnn MMooddee..
After programming the transmitter, wait
10-seconds, the parking lights will turn off. Programming
transmitter(s) is now complete.
note: To ensure proper system operation, use the trans-
mitter at a distance of greater than 18 inches from the
control module.
PROG
PROGPROG
ARM
ARM
DISARM
DISARM
PROG
PROG
ARM
ARM
DISARM
DISARM
note: If the WHITE (H1/9) wire at the control module
is not cut the doors will lock 3-seconds after turning the
ignition on.
G21994_04-06.qxd 12/11/06 3:36 PM Page 32