Filter
Top Products
BBaassiicc OOppeerraattiioonn
After installation is completed, and the remote control’s
batteries have been installed you are ready for operation.
Turn on all related equipment first. Ensure that the
TV/Video Monitor is switched to video input mode.
NNOOTTEE::
The same icon or word on the disc player’s front
panel or on the remote always bear the same meaning.
Most functions can be controlled by both the front
panel controls and the remote controls. There are a few
functions which are only controlled by either just the
controls at the disc player or the remote control.
PPLLAAYY
1. Press POWER on the front panel of the disc player.
2. Press EJECT to remove any disc loaded into the player.
3. Load a single disc into the player disc slot, with the
label side up. The disc will slide in automatically.
4. Press PLAY/PAUSE.
The player will identify the disc format and display the for-
mat on the monitor. After a few seconds the disc will play
automatically. If a disc title or menu displays on the
screen, you can use the cursor (S/T/W/X) buttons or
the number key pad on the remote control to pick the title
or menu selection.
While the disc is playing you can press PLAY/PAUSE to play
or pause the disc.
NNOOTTEE::
If while playing the disc, the picture is not
shown in full screen, or some part of the picture is hid-
den, or the picture has no color, you probably have the
wrong TV format set (selectable between PAL and
NTSC). Refer to the System setup instruction given
later in this manual .
If the hand
,
symbol appears on the TV screen when
an operation is attempted, this means that this com-
mand is not allowed in the present state of the player.
© 2004 Directed Electronics, Inc.
1155