Filter
Top Products
CCOOAAXXIIAALL OOUUTTPPUUTT
If you use the coaxial terminal to output the audio signal, you
need to set the audio output to SPDIF/RAW or SPDIF/PCM.
1. Press the SETUP button to display the Setup Menu screen.
Use the the (S/T/W/X) buttons and highlight Audio Setup.
Press the ENTER button.
2. Use the the (S/T/W/X) buttons and highlight Audio
Output. Press the ENTER button.
3. Press the (
X) button to enter the right-hand side of the
sub-menu.
4. Press the (S/T) buttons to highlight SPDIF/RAW OR
SPDIF/PCM, then press the ENTER button.
5. Press the SETUP button to exit the setup menu.
NNOOTTEE::
If you are not going to use the coaxial audio out-
put, set the audio output to Analog to avoid mixed signals.
© 2004 Directed Electronics, Inc.
2255