Filter
Top Products
19
Connecting the DIRECTV Sat-Go to Power
3
12
For AC power
1. Remove the cable cover from the cable compartment located in the TV receiver. The AC
power cable is permanently connected to the receiver.
2. Remove the soft plastic cover plug from the top of the case and lay the AC power cable into
the provided groove.
3. Plug the AC power cable into a grounded 3-prong outlet.
4. Replace the cable cover.
For DC power
1. Remove the DC cable from the DIRECTV Sat-Go case.
2. Remove the TV from the DIRECTV Sat-Go case.
3. Connect the DC cable to the DC connector on the side of the receiver and to a DC power
source such as a cigarette lighter in a car or boat. The DC power cable is not permanently
connected to the TV.
Note:
The AC and DC cables should never be plugged into a power source at the same
time.
Hibernation Mode
If you fold down the Liquid Crystal Display (LCD) when TV power is on, the LCD and speakers
are turned off automatically. (The power to the TV is not turned off.)
Setting Up Your DIRECTV
®
Sat-Go
SatGo_03-30-07(converted).indd 19SatGo_03-30-07(converted).indd 19 5/18/07 4:48:27 PM5/18/07 4:48:27 PM