DirecTV SAT GO Satellite TV System User Manual


 
2
16) Avoid operating the TV in extreme heat, humidity or areas affected by dust. The operating
temperature range is 0~50°C (32~122°F). The operating humidity range is 20~90%.
17) Do not use sharp tools such as a pin or a pencil near the TV, as they may scratch the LCD.
18) Do not use a solvent, such as benzene, to clean the TV, as it will damage the LCD surface.
19) The acrylic exterior surface of the TV can become rough or even sharp as it is exposed to wear.
Exercise caution when handling the unit to avoid scratches or minor cuts.
CAUTION: Avoid moisture to reduce the risk of re or electric shock. The DIRECTV
®
Sat-
Go system should not be used near water (for example, kitchen sink, bathtub, pool, damp
basement). Also, never spill liquid on the receiver, and do not place vases or other vessels
containing liquid on top of it.
Ensure proper ventilation — the vent slots on the DIRECTV Sat-Go system must be left
uncovered to allow proper air ow to the unit. Blocking the air ow to the unit could impair
performance or damage your receiver and other components.
Do not stack electronic components or other objects on top of the DIRECTV Sat-Go system.
Also, do not stack the receiver on top of a “hot component” such as an audio power ampli er.
Protect your components from power surges by connecting all the components before plugging
any power cords into the wall outlet. Use of a surge protector is also recommended.
Don’t overload power outlets or extension cords, which can result in the risk of re or shock.
It’s also important to use only the type of power source indicated on the marking label or in this
manual.
Avoid audio hum or interference by inserting all cable plugs rmly into their jacks. Also, place
Audio/Video (A/V) cables to the sides of the TV back panel rather than down the middle once
connected. Try not to coil any twin-lead cables and keep them away from A/V cables as much as
possible.
Never insert objects of any kind into any openings in the DIRECTV Sat-Go system (other than
the DIRECTV access card as detailed in this manual).
Place it on a at, hard surface — do not operate the DIRECTV Sat-Go system on a carpet or
other padded surface.
Always unplug your DIRECTV Sat-Go system before moving it.
Always unplug the DIRECTV Sat-Go system, TV and other equipment before you connect or
disconnect any cables.
CAUTION: Electric Shock — never attempt to disassemble the DIRECTV Sat-Go system
yourself; always take it to a quali ed service person when repair is required. Opening or removing
covers may expose dangerous voltage or other risks, and incorrect reassembly can cause shock
when receiver is subsequently used. Attempted self-repair may also void your warranty. Changes
or modi cations not expressly approved by the party responsible for compliance (by the warranty
or by the manufacturer) could void the user’s authority to operate the equipment.
Do not drop your DIRECTV Sat-Go system, or expose to sudden or jarring movements, and
always move it with care. Protect the LCD screen from impact.
Have your DIRECTV Sat-Go system professionally serviced (do not attempt to service it
yourself).
Any changes or modi cations in construction of this device which are not expressly approved by
the party responsible for compliance could void the user’s authority to operate the equipment.
The DIRECTV Sat-Go system should be stored between -20°C and 60°C (-4°F to 140°F).
For your information:
The identi cation sticker can be located underneath your DIRECTV Sat-Go system.
The telecommunication network voltage used is the category number 3.
Notices
SatGo_03-30-07(converted).indd 2SatGo_03-30-07(converted).indd 2 5/18/07 4:48:00 PM5/18/07 4:48:00 PM