Filter
Top Products
19
SETUP AND CONNECTIONS
STEP 2: PLACE BATTERIES IN THE REMOTE
CONTROL
Follow these steps whenever you need to install or change the batteries in your TV’s
remote control.
1. Remove the cover from the battery compartment.
2. Insert batteries into the battery compartment, matching the + and – end of each
battery.
3. Replace the cover.
STEP 3: COMPLETE THE INTERACTIVE SETUP
Interactive setup appears when you turn on your TV for the first time . Follow the steps to
configure the basics of your system, such as setting up the time and day, searching for
available channels, and setting up speakers. To run it again, select Assistance from the
Main menu, then select Interactive Setup. For more details, see the section “Getting
Assistance” on page 81.
STEP 4: ORDER PROGRAMMING
You should decide if you would like to receive DIRECTV
®
programming*. To receive
DIRECTV
®
programming, your satellite dish antenna must be installed and pointed
correctly. You must also contact your service provider, DIRECTV.
Programming with DIRECTV: Call 1-800-347-3288
When you order programming, you need to know your access card number. To get the
number, select Assistance from the Main menu and then select System Test. Wait for the
system to run all of its tests. The access card number is displayed at the end of the system
test. Write the access card number in the space below for easy reference:
Press and slide to remove.
______________________________
*DIRECTV programming is
provided in accordance with the
terms and conditions of the
DIRECTV Customer Agreement,
a copy of which is provided with
your first DIRECTV billing
statement. DIRECTV is a
trademark of DIRECTV, Inc., a
unit of Hughes Electronics Corp.,
and is used with permission.
______________________________