Filter
Top Products
29
USING THE REMOTE
8. Attach the supplied Template to the remote control to enter the function
names of the learning buttons (A to H) you have programmed. Use a
ballpoint pen, etc. to write the function names.
1 2 3
4 5 6
7 8 9
OK
0
USE LEARN
+100 / ENTER
A B
C D
E F
G H
Cancelling the learned operating codes
1. Set the USE/LEARN switch to the “LEARN” position.
USE LEARN
2. Hold down the button of the function to cancel on the remote control
for about 1 second until the LEARN indicator lights up.
3. Hold down EXIT and MUTE at the same time for about 6 seconds
until the LEARN indicator goes off after blinking.
Note:
You cannot cancel the programming if you release the button while the indicator
is blinking.
4. Set the USE/LEARN switch to the “USE” position.
USE LEARN