28
USING THE REMOTE
LEARNING OPERATING CODE OF
ANOTHER REMOTE CONTROL
This remote control is capable of learning operating codes from most infared
remote control transmitters. You can control the functions of your TV and a
variety of video/audio equipment with the supplied remote control only.
The A to H buttons can be used as the Learning buttons.
1. Set the USE/LEARN switch to the “LEARN” position.
USE LEARN
2. Place the supplied remote control and the remote control transmitter to
be learned, head to head approximately 1 to 3 inches (3 to 8 cm) apart.
POWER
TV/VCR
321
654
987
TV/VIDEOTV/SAT
REW RLAY FWD
PAUSE STOP SLOW
TV/VCR
POWER
SWAP
SOURCE
POP
ANTENNA
STI LL
W
H
O
G
U
I
D
TV
CABLE
VCR
DVD
3. Hold down the button to learn (A to H) on the supplied remote control
for about 1 second until the LEARN indicator lights up.
When you press a button other than a Learning button, the indicator
will blink.
4. Hold down the button of the function to be learned on the other remote
control transmitter for about 3 seconds until the LEARN indicator goes
off.
Note:
If the LEARN indicator blinks, the supplied Remote Control cannot learn the
operating code or an error has occurred.
5. Repeat steps 4 and 5 for storing other functions into other buttons.
6. Set the USE/LEARN switch to the “USE” position.
USE LEARN
7. To check your programming, operate the appropriate equipment with
the supplied remote control. If the equipment does not operate as
expected, repeat steps 1 to 7.
If needed, try changing the distance between the two remote controls.
Supplied Remote
Control
Head to Head
1-3 inches apart
Remote Control to be
learned
LEARN
indicator
USE/
LEARN
switch
EXIT
MUTE
Learning
buttons
LEARN/
TV/VIDEO TV/SAT
REW RLAY FWD
PAUSE STOP SLOW
TV/VCR
POWER
SWAP
SOURCE
POP
ANTENNA
STILL
S
E
T
U
P
T
I
T
L
E
S
U
B
T
I
T
L
E
A
U
D
I
O
F
E
T
C
H
W
H
O
G
U
I
D
E
I
N
F
O
REC RETURN EXIT
MUTE
PIC SIZE
A B
C D
E F
G H
1 2 3
4 5 6
7 8 9
OK
0
USE LEARN
CH
VOL
P
O
P
C
H
S
K
I
P
-
S
K
I
P+
MENU
+100 / ENTER
TV
CABLE
VCR
DVD
ENTER
O K
( )