Filter
Top Products
82
GETTING ASSISTANCE
RUNNING THE INTERACTIVE SETUP
You should have completed the interactive setup the first time you plugged in your TV.
However, if you need to access the interactive setup again, you can access it through the
Assistance menu.
1. Press MENU on the remote control to access the main menu.
2. Select Assistance from the main menu.
3. Select Interactive Setup and follow the on-screen directions.
RTN Help
1 Interactive Setup
2 Antenna info
3 Dish Pointing...
4 New Access Card
5 System Test
6 Off-Air Guides
7 Upgrades...
The interactive setup process allows you to
complete all steps or selectively skip steps.
The steps involved in the interactive setup include:
•Setting the time and date • Specifying your satellite dish antenna type
•Searching for channels • Entering Zip Code
•Setting up speakers • Running the Signal Meter
•Selecting an audio processor • Running the system test
Note that if you do not subscribe to DIRECTV
®
programming, you can select “Skip this
step” for running the system test.
GETTING ANTENNA INFORMATION
The Antenna Info menu helps you measure the strength of all available TV channels. It
will help you adjust any off-air TV antennas. (The actual adding of channels is done by
using the Channel Search menu.)
To access the Antenna Info menu:
1. Press MENU to bring up the main menu.
2. Select Assistance.
3. Then select Antenna Info.
A dialog box reports the status of the signal search and lists channels that are being
received or have been received from all off-air antennas. To switch between antennas,
highlight a channel and then press ANTENNA on the remote control.
If you decide to subscribe to
DIRECTV, we strongly recommend
that you have the satellite system
professionally installed.
Installation can be arranged through
the dealer where the TV was
purchased.