Filter
Top Products
Using the Profiles
52
After a spending limit is set and the system is locked, you must enter a password to
purchase a Pay Per View program that costs more than your spending limit allows.
The system will then temporarily unlock the limits you have set until the power is
turned off. When the system is turned back on, the system will be locked again.
SETTING THE DIRECTV RATING LIMIT
The Set Rating Limit menu enables you to set a maximum viewing limit for rated
DIRECTV movies (based on the MPAA ratings system), as long as the DIRECTV
program provider has transmitted the proper code.
• Note that the ratings limit cannot be enforced if a DIRECTV program has not
been rated, if rating information for that program is not transmitted by the
program provider, or if the system has not been locked.
1. Select a user.
2. Select DIRECTV Setup.
3. Highlight Set Rating Limit and press OK.
Use the arrow buttons on the remote control to move the selector up and down.
4. Use the up and down arrows to move the rating selector to the highest rating
you want to be able to view. In the preceding illustration, movies that are rated
up to and including a PG-13 rating can be viewed.
After the rating limit is set and the system is locked, you must enter the system
password to watch programs with a rating higher than the limit. The system will
then temporarily unlock the limits you have set until the power is turned off. When
the system is turned back on, the system will be locked again.
THE TV SETUP
You can establish TV channel lists, set spending limits, and set rating limits for TV
programs using the TV Setup menu.
Please note that the rating
limit you set while in the
DIRECTV Setup menu
apply only to DIRECTV
programs—they do not
apply to TV programs.
To set limits for TV
programming, select a
profile, select TV Setup
and then select Set TV
Rating or Set Movie
Rating.
Important!
You need to lock the
system in order for rating
limits, channel limits,
and spending limits to
go into effect.
To edit the limits after
you lock the system, you
need to enter the system
password. See “Locking
the System” for details.