Dish Network 5.0 Universal Remote User Manual


 
14
TV/VIDEO BUTTON
If you connect the receiver with its back panel TV ANTENNA/CABLE
IN and TV SET OUT ports, use this button to switch the receiver
between the satellite signal (connect it to the SATELLITE IN port) and
another video signal like a cable or broadcast TV antenna input
(connect it to the receiver’s TV ANTENNA/CABLE IN input).
Note: Your remote control will either have the TV/VIDEO button or
the SD/HD INPUT button, but not both.
SD/HD INPUT BUTTON
Press the SD/HD INPUT button to toggle between HD Output mode,
where only the HD video outputs are enabled, and SD Output mode,
where only the SD video outputs are enabled. Consult your receiver
user’s guide for other uses of this button.
Note: Your remote control will either have the TV/VIDEO button or
the SD/HD INPUT button, but not both.
POWER BUTTONS
Press the blank POWER button to turn the receiver on or off.
Press the TV POWER button to turn your TV off and on.
Note: You must set up the remote to control the TV for the TV
POWER button to work. See Setting Up to Control Other Devices on
page 8.
VOLUME BUTTON
Press this button to raise (+) or lower (-) the TV sound volume.
Note: You must set up the remote to control the TV for the VOLUME
button to work. See Setting Up to Control Other Devices on page 8.
text_dishpvr.fm Page 14 Tuesday, March 2, 2004 12:35 PM